Pastel Gray Blue Acrylic Sheet

Suggested settings
for 3 mm (1/8") thick acrylic:

To CUT: Power - FULL; Speed - 160

To ENGRAVE: Power - FULL; Speed - 1000

We recommend testing a small patch as each machine may
perform differently. Settings should be adjusted accordingly if the patch test is not successful.

Please note that some acrylic settings (i.e. for glitters
and marbles) might need to be adjusted by increasing power and slowing speed as they may be slightly thicker.

Please allow a +/- ½ inch variation for length and width sizes, and a +/- 30% variation in thickness for all acrylic sheets. The corners/edges on acrylic sheets will be unfinished or slightly chipped from cutting down to size. 

Please note that our products are typically paper masked and prepared for laser engraving, with some styles featuring a protective plastic film. While the plastic film is deemed laser-safe, we advise removing it and substituting it with a paper masking option for optimal results. Should you observe any lifting or tearing of the paper masking, we recommend removal and replacement for the best laser processing experience.

To avoid warping, store acrylic at no more than a 10 degree angle standing or lay flat with smaller pieces on top.